Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
MG4
New Contributor III

FG-120G v7.4.7 not showing Proxy-Mode in the GUI or CLI commands for Proxy-Mode

Hi everyone,

 

I'm currently trying to set up a new FG-120G, and I'm currently stuck with enabling the proxy mode inspection. I tried following these two instructions for activating proxy mode inspection:

- https://community.fortinet.com/t5/FortiGate/Technical-Tip-How-to-enable-the-visibility-of-Proxy-Mode... 

- https://community.fortinet.com/t5/FortiGate/Technical-Tip-Inspection-mode-option-is-not-visible-unde... 

 

I activated "Policy Advanced Options" under Feature visibility. Then I tried the commands in the CLI, but there is no "gui-proxy-inspection" under "config system settings". Even under "config system global" there is no "proxy-and-explicit-proxy".

I also tried restarting the FortiGate after activating the Feature "Policy Advanced Options", but the commands still don't work. (since the command "fnsysctl killall httpsd" did nothing)

 

Are there any requirements or settings that I'm missing to activate proxy mode?

View of creating a policy with "Policy Advanced Options" activated:

Policy ViewPolicy View

1 Solution
MG4
New Contributor III

Found the problem, the FG was still in policy-based mode and not profile-based mode.

View solution in original post

1 REPLY 1
MG4
New Contributor III

Found the problem, the FG was still in policy-based mode and not profile-based mode.

Announcements
Check out our Community Chatter Blog! Click here to get involved
Labels
Top Kudoed Authors