Error -23 Discard the setting command fail

[yaronbeny7]

Hello,

i want to change switch mode to internal mode on my fortgate.

The things I did before:

1.removing internal rules.

2.change from dhcp to manuel

than on cli:

config system global

set internal-switch-mode interface

end

then i got this error (attached file)

thanks

[yaronbeny7]

i did it and see the file attached with the error.

how can i fix it please ?

[jintrah_FTNT]

hi,

The subnet is already used for internal6 interface as indicated from the error message. Choose a different subnet, say, 10.10.10.1/24 for the interface.

Regards,

[yaronbeny7]

so i want to delete this subnet (port 6) how can do it please ?

At the end of the process i want to configure only port1 with the the following ip:192.168.1.99 255.255.255.0

when i will able to access the broswer with https://192.168.1.99

i will configure the other ports.

[jintrah_FTNT]

Ok, do this.

config system interface

edit internal1

unset ip

next

edit internal1 set ip 192.168.1.99 255.255.255.0 set allowaccess http https ssh next end

[rwpatterson]

jintrah wrote:

Ok, do this.

config system interface

edit internal6 <-Should be 6, no?

unset ip

next

edit internal1 set ip 192.168.1.99 255.255.255.0 set allowaccess http https ssh next end

Either way, my preference would be to connect to whatever port you could now get to (internal6), make a backup, edit the interface IPs in there, and restore from the GUI. After the reboot, connect again to your preferred port, and configure away.

[jintrah_FTNT]

Yes, it should be internal6. Sorry for the typo.

[yaronbeny7]

Everthing is ok now.

Thanks