Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
franz
New Contributor

Enable sflow + ntop

Hello, i enabled the sflow protocol on my fortigate 600C, but i receive few informations about the connections, why? Regards Franz config system sflow set collector-ip x.x.x.x set collector-port 6343 end config sys interface edit set sflow-sampler enable set sample-rate 512 set sample-direction both set polling-interval 30 next end
2 REPLIES 2
netmin
Contributor II

It depends on the the type of traffic that is monitored. Here' s another opinion about sFlow (and NetFlow, which was added in 5.2 btw.): http://searchnetworking.techtarget.com/opinion/Traffic-analytics-in-the-new-IT-landscape-NetFlow-vs-sFlow
Jeff_FTNT
Staff
Staff

Most port on FG600C is NP4 port, so traffic is offloaded to NPU. You may try to disable NP4 fastpath .Thanks.
Announcements

Select Forum Responses to become Knowledge Articles!

Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.

Labels
Top Kudoed Authors