Enable NAT from console

[ZiPPy]

In troubleshooting an issue, the operation mode was changed from NAT to Transparent. I' m having trouble trying to set it back to NAT via the CLI. Per the manual: config vdom edit vdomain3 config system settings set opmode nat end config system interface edit port1 set ip 192.168.10.100 255.255.255.0 end But this isn' t working, I don' t even see a vdom option, so I assume its deeper within the config.

[ZiPPy]

So at the FW# prompt I type in the following FW# config system settings (settings)# set opmode nat (settings)# end I run the sh command and go through the entire config, and I still see transparent. If I do a sh in the ' config system settings' it comes up with: config system settings end

[rwpatterson]

Just ran

config system settings  
  show 

from my device. It shows nothing as well. Looks like a factory reset is in order.

[ZiPPy]

I think so. I hosed it pretty good.

[rwpatterson]

At least you didn' t brick it.