Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
wotik
New Contributor III

Disabling UDP ports 500 and 4500

Hello everyone

 

In Local in policy in my FG, UDP ports 500 and 4500 are active by default. I do not use IPsec and would like to disable these ports.

 

How can I do this in CLI?

Best Regards,
Wojtek
Best Regards,Wojtek
1 Solution
parteeksharma

Hi Wotik,

Hope you are doing good.

 

You can disable the ports 500 and port 4500, using local in policy, kindly check below document to enable local in policy through cli:

https://docs.fortinet.com/document/fortigate/6.2.13/cookbook/363127/local-in-policies

Regards,

Parteek

View solution in original post

1 REPLY 1
parteeksharma

Hi Wotik,

Hope you are doing good.

 

You can disable the ports 500 and port 4500, using local in policy, kindly check below document to enable local in policy through cli:

https://docs.fortinet.com/document/fortigate/6.2.13/cookbook/363127/local-in-policies

Regards,

Parteek

Labels
Top Kudoed Authors