- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Disable per-mapping en Object group
When the Fortimanager was loaded, it was done after loading the Network, so they were left in a single address group, several mappings per device, they asked to add a new address, I wanted to know what would happen if per-mapping was disabled.
Solved! Go to Solution.
- Labels:
-
FortiManager
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Finally I did a test with one more group that was in the same condition, I disabled per-mapping for that IP group leaving only the main one.
The reason was because I had another adom in the same condition, a single object with many mappings, which made it difficult to add a new IP.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi PaulR
This article describes the per-mapping behaviour.
https://community.fortinet.com/t5/FortiManager/Technical-Tip-Per-Device-mapping-behaviour/ta-p/26486...
If you don't mind, could you please tell me the reason why you want to disable the per-mapping?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Finally I did a test with one more group that was in the same condition, I disabled per-mapping for that IP group leaving only the main one.
The reason was because I had another adom in the same condition, a single object with many mappings, which made it difficult to add a new IP.
