Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Disable FortiLink discovery
Hello Gents,
Kindly Am asking if there is a way to use Forti ink between Forti Switches and in sometime disable the discovery
which mean I have two FortiGate Firewall on different branch and each one connected with some Forti switches
I tried to make uplink between both branches through Forti switches but I discovered because of the uplink ,switches can discovered on each firewall So we need to make the uplink and on same time disable the discovery So kindly advice.
Labels:
- Labels:
-
FortiSwitch
2 REPLIES 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
To disable auto topology (not discovering Fortilink), use the following commands:
config switch auto-network
set status disable
end
https://docs.fortinet.com/document/fortiswitch/7.4.0/fortilink-guide/657004/zero-touch-management
or in port level:
config switch interface
edit port3
set auto-discovery-fortilink disable
- Emirjon
If you have found a solution, please like and accept it to make it easily accessible for others.
If you have found a solution, please like and accept it to make it easily accessible for others.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thanks for your reply
Let me check this steps
