Direct all traffic received on WAN2 to specific internal address (Forti 100d)

EricomSoftware · ‎03-23-2016

Hi All,

I have tried to direct all traffic received on WAN2 to specific internal address.

I have created a virtual IP rule to shift all traffic to the external IP of the WAN2 interface but it doesn't work.

* i have also create a firewall rule to allow the traffic in.

Can someone refer me to an "how to" on this matter?

Thanks!

Fullmoon · ‎03-23-2016

VIP is not needed on your design use Policy Based Route (PBR) instead

Fortigate Newbie

ede_pfau · ‎03-23-2016

If you mean like a "passthrough-all" rule on a home router? Then use a VIP = destination NAT.

If you're new to FortiOS I'd recommend to stay away from Policy routing as it's not that 'visible' in the GUI. NAT should suffice.

If it doesn't work for you, please post the config (VIP, policy) in text form.

Ede

"Kernel panic: Aiee, killing interrupt handler!"