Deleting an Interface

[Marcos_FDS1012]

I need to delete ima Interface, but I can't figure out how to do it? I want to remove it and put it in SEM_USO

[funkylicious]

hi,

you cannot delete a built-in/default interface.

what is SEM_USO where you want to put it or what do you actually want to do with it ? as long as there's no IP configured on it and has 0 references, you can basically use it for whatever you want to configure on the FortiGate.

[Marcos_FDS1012]

I don't think I've explained the director I want to remove Physical Interface where it's yellow and put Hardware Switch where it's green.

[funkylicious · Accepted solution]

it should be available for being part of the hardware switch.

have you tried editing the HW SW and adding it ? its not available for selection ?