Creat Dial-up interface on FGT (VPN-Ipsec with remote site_Dynamic_IP)

[IT_ZD]

Hello,

I hope you are well,

I need your help "if possible" to configure a dial-up interface on a sub-interface in order to use it for an IPSec VPN link (First Is it possible ?)

I tried to configure it by creating a standard VPN tunnel behind a NAT, then I edited the configuration by replacing the interface (IP Static) with a dial-up interface, the problem is that I can't save it and I get an error code -9999: -9999.

Here's a capture of the error and the topology target, knowing that I'm on migration from an ASA to a Fortigate (Fresh install).

ASA configuration :

Regards.

[IT_ZD]

so I can't modify the interface after creating the tunnel Okaaayyy

Otherwise, for my scenario above, the interface that I need to create is a Dial-Up interface ? because on the Old_ASA to be I have a Dial-Up interface.

Ok I'll try and get back to you. Thx a lot hbac

[IT_ZD]

Hello Hbac,

Sorruy for the late,

Ok its noted, I back to you when done.

Thx again.