- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Connecting to branch/leaf AP
Once an AP is deployed as a branch/leaf AP is there anyway to connect directly to its web interface to make changes?
Maybe over mesh backhaul?
Thanks,
Paul
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Paul,
Yes you can do that. Once the FAP gets connected as Mesh Branch/Leaf it gets an IP address in the same-subnet as the Mesh Root. You can either HTTP into the FAP or Telnet into the FAP to do the configurations.
Telent has more options than HTTP.
If you can let us know, what are exactly trying to do, I can help with those CLI for FAP.
Thanks,
Balaji
Balaji
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you. The problem I am having is related to the firewall policy. The FortiGate does not let me create a policy using the wl.mesh interface.
Scenario:
My (wired) computer is connected to the DMZ interface of a 60CWiFi and trying to access the AP using the wl.mesh IP but I am not able to create a DMZ--->wl.mesh policy to allow this traffic, so how am I suppose to access the AP?
I am able to ping the AP from the FortiGate CLI successfully.
Thanks,
Paul
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
wl.mesh is only used to connect mesh leaf AP, and could not be used to connect normal host.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ok thank you. How do I connect to it then using HTTP or Telnet if I want to make a change?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can telent into the AP from FGT.
FGT# config wireless-controller wtp FGT(wtp) # edit FP111111111111 (your WTP) FGT(FP111111111111) # set login-enable enable FGT(FP111111111111) # end FGT# execute telnet A.B.C.D
Trying A.B.C.D
Connected to A.B.C.D
FP111111111111 login : admin (this default)
FP111111111111 :
Balaji
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Have you tried TELNET to the AP on the controller?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What's the default password? I tried to just hit enter (no password) but I' denied.
Thanks,
Paul
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
By default FAP should not have any password.
FAP1111login : admin (Default)
After providing the "admin" as login it should get you into the FAP.
Balaji
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is it possible to reset the AP password from the controller? Apparently there is a password but it's unknown.
