Configuring VLAN!

cbloom · ‎06-02-2024

on a fortiswitch with Firmware v7.2.4.

How to ensure that traffic between port 01 (SW1) and port 02 (SW2) is tagged with the correct VLAN IDs and is not set to VLAN 1 by default. Should I change the native VLAN on each port?

omegle xender

DPadula · ‎06-02-2024

Hi cbloom
We have a article for that: https://community.fortinet.com/t5/FortiNAC/Technical-Note-Best-practice-for-manually-changing-VLANs-...

If the switches are connected to fortigate you can do from FGT GUI.

ozkanaltas · ‎06-02-2024

Hello @cbloom ,

When you open the box, FortiSwitch comes with native vlan as 1.

If you use FortiSwitch on standalone mode, you can review this document about cli commands. And you can check with these command native vlan settings.

https://docs.fortinet.com/document/fortiswitch/7.4.3/fortiswitchos-administration-guide/146335/confi...

If you have found a solution, please like and accept it to make it easily accessible to others.
NSE 4-5-6-7 OT Sec - ENT FW

PaigePhillips · ‎06-14-2024

Thanks for answering, you made my day.

Configuring VLAN!

Nominate a Forum Post for Knowledge Article Creation