Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
johnlloyd_13
Contributor

Configure HA MGMT interface for OOB

hi,

i just built HA active-passive.

i lost HTTPS on the secondary FW since it sync'd with primary FW MGMT (lan1) interface.

i was trying to configure secondary HA MGMT interface but doesn't allow me.

my question is, how do you "default"/remove MGMT config on secondary FW lan1 interface?

 

FW01_SEC (ha) # set ha-mgmt-status enable

FW01_SEC (ha) # config ha-mgmt-interfaces

FW01_SEC (ha-mgmt-interfaces) # edit 1

new entry '1' added

 

FW01_SEC (1) # set interface lan1

node_check_object fail! for interface lan1

 

value parse error before 'lan1'

Command fail. Return code -23

 

FW01_SEC (1) # set interface

<string>    please input string value

a       interface

 

FW01_SEC # get system interface physical lan1

== [onboard]

        ==[lan1]

                mode: static

                ip: 172.20.8.20 255.255.255.0    <<< I NEED TO SET SEC FW TO .21

                ipv6: ::/0

                status: up

                speed: 1000Mbps (Duplex: full)

                FEC: none

                FEC_cap: none

Thanks,
John
Thanks,John
2 REPLIES 2
Anthony_E
Community Manager
Community Manager

Hello John,


Thank you for using the Community Forum. I will seek to get you an answer or help. We will reply to this thread with an update as soon as possible.


Thanks,

Anthony-Fortinet Community Team.
srajeswaran
Staff
Staff

Hi John,

 

Are you still facing this issue? Ideally this should have fixed after fixing the issue in - https://community.fortinet.com/t5/Support-Forum/Unable-to-add-lan1-in-MGMT-Interface-Reservation/m-p...

Regards,

Suraj

- Have you found a solution? Then give your helper a "Kudos" and mark the solution.

Labels
Top Kudoed Authors