- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Configuration and Installation Status widget missing from managed device dashboard
I have a FortiManager managing 60C's and 60D's both running firmware version 5.0.11 and 4.0MR3 Patch 18. On the 60C's no matter what version of F/W they are running I cannot see the Configuration and Installation Status widget on the dashboard for that particular device. I can see it fine on the 60D's. Has anyone ran into this before?
Any help would be greatly appreciated.
Thanks,
- Labels:
-
FortiManager
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Maybe too simple, but does it work with a different browser or after you have cleaned your browser cache?
Regards,
Ralph
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Tried that, it didn't work. Thanks for the input though.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
what is the FMG version? we may need FMG db config to investigate the issue
if you can provide a FMG db, you can open a ticket and upload your config. send me a message for the ticket ID, I will follow up your case
Thanks
Simon
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
would there be a setting in the CLI or GUI that would remove this just from the 60C's?
Thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
what is the FMG version? can you check "exec dm revlist" for that device, revision list looks OK?
Thanks
Simon