Config and Set command in CLI is not working while enabled VDOM

[Dancoby]

My machine is 60Dwifi with firmware 5.0.13

Having encountered a problem during the setup procedures about the site to site IPSEC connection with my VPC AWS after enabling VDOM. After setting up the Phase 1, phase 2 and it's tunnels, the Downloaded VPN Configuration from AWS asks me to config with following commands under VDOM root,

config system interface   edit "vpn-f8fe7ad1-0"       set vdom "root"       set gwdetect enable       set detectserver "xxx.xxx.xxx.xxx"   nextend

However, it give me this,

 

FWF60D4615023625 # config system interface

6735: Unknown action 3

Command fail. Return code -1

BTW, is "Set BTU xxxx" is not working on 60D?

Really need to settle these problems.... thank you so much!

[MrSinners]

Hello,

After you enable VDOM mode, you have to navigate to the VDOM in the CLI:

# config vdom

# edit root

Then you can add the commands you listed.