Change mode from switch to interface wont work via CLI

[Marko]

I just did a factory reset on my 70D and was going to change mode on it,

removed DHCP, policy. There is no Ref. left according to the interface page.

And in the CLI

FGT70D # config system global FGT70D (global) # set internal-switch-mode interface FGT70D3 (global) # end FGT70D #Nothing happens, even if I do a manual reboot it wont change mode. 

Any ideas?

[Dave_Hall]

See this thread.

[Marko]

Dave Hall wrote:

See this thread.

I did read that and one more that I found when searching, but now this is solved, how? I did as the other thread says,  with the backupfile, but I needed to write in set internal-switch-mode to HUB and then via CLI run it again back to interface..