Change mode from Switch to Interface

[v20100]

Hi Very new to Fortigate. New installation. first post here!

The units are 200D

I am trying to change the global mode from switch to interface I use the command 'set internal-switch-mode interface' but fails with the following message: "Command parse error before 'internal-switch-mode'. Command failed, return error -61 I tried via the management port CLI and also via USB with FortiExplorer CLI I did a factory reset, removed the dhcp server and remove the policies as per post found in this forum. Not sure what else I need to do. When I type 'set help' and look at all the commands, I cannot see any that start with internal. I wonder if there is a new command now, or a different way to do it

Any advice would be appreciated

Thanks in advance

[Toshi_Esumi]

I have only limited experiences with 200Ds. But it would be dependent of the version of software. What is yours?

[Toshi_Esumi]

Or, does 200D even have switch interfaces? Somebody else must know about the architecture.

[Toshi_Esumi]

Sorry for throwing random posts. But likely it supports only interface mode, and some ports are integrated into "virtual-switch", which you might want to split. Check "show sys virtual-switch" unless somebody else replies with the exact answer.

[v20100]

Hi

Thanks for everyone that replied.

I found the solution via google. The command to use was:

config  sys virtual-switch

delete lan

cheers