Cant direct traffic over WAN2 using LLB

[flonix]

Hello,

I have searched the forums but can not find an answer to this!

I have a Fortinet 60E and am trying to setup a couple of devices to go out via WAN2. I have enabled WAN LLB and have both WANs in there. I have then created a WAN LLB Rule that everything from one PC should go out via the WAN2 interface but it isnt working.

I have attached a screenshot of the WAN LLB config and the Rule is as follows:

Name: Test1

Source: IP of PC

Destination: all

Criteria: 

Members: wan2

There is already a default rule which contains the following:

Name: wan-load-balance

Source: All

Destination: All

Criteria: Source IP

Members: All

Pulling my hair out here!

Thanks,

Daniel

[ericli_FTNT]

flonix wrote:

Hello,

I have searched the forums but can not find an answer to this!

I have a Fortinet 60E and am trying to setup a couple of devices to go out via WAN2. I have enabled WAN LLB and have both WANs in there. I have then created a WAN LLB Rule that everything from one PC should go out via the WAN2 interface but it isnt working.

I have attached a screenshot of the WAN LLB config and the Rule is as follows:

Name: Test1

Source: IP of PC

Destination: all

Criteria: 

Members: wan2

There is already a default rule which contains the following:

Name: wan-load-balance

Source: All

Destination: All

Criteria: Source IP

Members: All

Pulling my hair out here!

Thanks,

Daniel

Hi Daniel,

So your two screenshots are identically same?

[flonix]

Yeah, was late when I posted it, looked at it with fresh eyes today and the issue turns out to be that WAN2 wasnt working although the WAN status monitor told me something else!

This is working perfectly.

Daniel