Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
jfgagnon
New Contributor II

Cannot delete interface

Hi!

 

I created a hardware switch interface type, with 2 physical ports, and cannot delete it.

It's grayed out, even if I try to disable them.

 

How is it possible to delete them, please?

 

TY

1 Solution
Toshi_Esumi
SuperUser
SuperUser

Go to GUI Interfaces view. At the end of the table, there is a Ref. column. I assume the number of reference is not 0. Then you can't delete it. If you click the number, you can see where it is referred. You need to remove the references first to be able to delete any objects not only an interface.

View solution in original post

12 REPLIES 12
Yemar
New Contributor II

Hi, 

When creating a hardware switch, it's common to also set up a VLAN, address object, and DHCP server. To delete the hardware switch interface, first check the VLAN under that switch to see the reference count.

If the reference shows dependencies, click to view them. Items with a reference count of "0" can be deleted. However, for address objects that match subnets, you need to go to the Address section under Policies and Objects, search for the specific address, and delete it.

After removing any necessary address objects, go back to the VLAN interface and check the reference count again. If it’s "0," you can delete the VLAN and reuse the interface.

isaiahW
New Contributor

To add to this, make sure you check DHCP servers and make sure one wasn't created. I found in my case I had set the setting for the interface to do dhcp but even once i turned it off the dhcp server was still sitting on the firewall.

Akb81
New Contributor

These guys are leading you astray , go in to Addresses and delete the interface . It will be under policy and objects > addresses as well as interface list . 

Announcements
Check out our Community Chatter Blog! Click here to get involved
Labels
Top Kudoed Authors