Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Cannot configure fortigate while is registered on fortimanager
Hi, I cannot configure a fortigate while is registered under a fortimanager 400A with an user with limited permission:
read-only on all section except firewall and utm that are in read-write mode.
All the web-ui result in read-only mode.
Can anybody help?
Thanks a lot
4 REPLIES 4
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I believe a later firmware version of the Fortigate devices give you the option for read or read-write for the entire firewall.
-DDSkier FCNSA, FCNSP FortiGate 400D, (2) 200D, (12) 100D, (2) 60D
-DDSkier FCNSA, FCNSP FortiGate 400D, (2) 200D, (12) 100D, (2) 60D
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ok, I' m waiting for latest release.
Best Regards
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Has anyone figured out a way around this. To be able to configure a fortigate directly via its web UI while registered under a FortiManager. When I login it is all read-only. The UI says:
This FortiGate is currently managed by a FortiManager Device.
All changes should be performed from FortiManager to avoid conflict.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
The later version of MR3 on the fortigate units allow you to click the " continue" button to gain local web-interface modification access directly on the firewall.
-DDSkier FCNSA, FCNSP FortiGate 400D, (2) 200D, (12) 100D, (2) 60D
-DDSkier FCNSA, FCNSP FortiGate 400D, (2) 200D, (12) 100D, (2) 60D
