Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
ehenvironments
New Contributor

Can you mix modes on a FortiSwitch? Managed by FG, but with customization through CLI?

I have used FortiSwitches in a couple locations, but always managed by a FG. 

 

I will have a need at a location soon for some advanced configuration to support IP Video traffic on one of the VLANs, but features like IGMP Snooping and Querier don't seem to be exposed in the FG interface.  Can you configure these settings through CLI while still being managed by the FG, or does FG management effectively wipe the configuration and load its own from the FG? 

 

If you can do both, can you configure with CLI at any time while connected to the FG, or only before or after adding it to the FG as a managed switch?

 

TIA,

 

-David

4 REPLIES 4
SecurityPlus
Contributor II

I would be curious to hear an answer to this as well .
tanr
Valued Contributor II

With the 3.6.x switch OS you could make some changes in the CLI after the switch became managed that stayed between firmware updates.  The one I used the most was setting switch ports to have discard-mode all-tagged.  Note that you can now set discard-mode from the FortiGate with 6.0.x, and upgrading to the 6.0.x firmware wiped my discard-mode settings on 1 of our 6 switches (a 124E).

 

Note that IGMP Snooping is supposed to be supported on managed FortiSwitches above 1xxE models, though release notes still list some bugs.

Duncan
New Contributor III

ehenvironments wrote:

...or does FG management effectively wipe the configuration and load its own from the FG? 

Yes, if you configure the switch via the FS CLI, your custom config will get wipe after making changes on the FG.

The proper way to do this is in the FG CLI. Use the commands 'config switch-controller managed-switch', 'edit <FS serial number>' then 'config igmp-snooping'.

ehenvironments

Excellent, thanks for the insight.  We will give it a try.

Announcements

Select Forum Responses to become Knowledge Articles!

Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.

Labels
Top Kudoed Authors