- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can't connect ipsec vpn
Hello,
I'm on a vm with a free license to test fortigate, but i have a problem, i can't connect to the ipsec vpn, i put the screenshot for the configuration so you can see what i do
- Labels:
-
FortiClient
-
FortiGate
-
IPsec
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @LucasMo,
Please collect ike debugs: https://community.fortinet.com/t5/FortiGate/Technical-Tip-Understanding-IPsec-iked-debug-logs/ta-p/2...
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can you also show the phase1 parameters on the FCT?
The IKE debug would need to be run on the FGT while reproducing the issue:
diagnose vpn ike log-filter name <phase1_name>
diagnose debug application ike -1
diagnose debug console timestamp enable
diagnose debug enable
To disable:
diagnose debug disable
diag debug reset
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello again, I changed to version 7.2.7 to have access to ssl vpn, but I still have the problem that when I try to connect, it loads and then tells me "vpn connection disconnected". And when i try to connect with the browser, it say that the ssl version is not compatible.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Here is the error that I have
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
What happened to IPsec VPN? For the new issue, you can refer to https://community.fortinet.com/t5/FortiGate/Troubleshooting-Tip-SSL-VPN-Debugs-Error-SSL-accept-fail...
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I stop the ipsec vpn, my boss told me to go for the ssl vpn
but this article didn't help me...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Obviously, the commands didn't work. You got command parse error. Please make sure you are using the right command.
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I just didn't have the command
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Which firmware version are you using? Can you provide the output of this command 'show full vpn ssl setting'?
Regards,