- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Can Not Create Trunk Group Member
Hi everyone,could you help me for this issue ?
When I want to two interfaces on fortiswitches for trunk group.I see that warnings and it can not allowed for adding these interfaces.However same switch I use trunk group for different interfaces.I live that issue for 49 and 50 interfaces.Additionaly,I use managed switch with fortilink
- Read-only reference to trunk interface when port is a member of a trunk.
- This port/trunk MAC value is not configurable.
- Read-only refereUser not allowed to configure this command.
- User not allowed to configure this command.
- User not alnce to trunk interface when port is a member of a trunk.
- Lowed to configure this command.
- Error: Static/Sticky MAC entry (id=5) exists in the trunk member port port5 !!!.
- Attribute set operator error, -651, discard the setting.
- Labels:
-
FortiGate
-
FortiSwitch
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @CEMS ,
Can you check if the interfaces you're trying to configure might already be part of another trunk group or not.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Error: Static/Sticky MAC entry (id=5) exists in the trunk member port port5 !!!. Also this warning change when I try different ports for example sometimes port4,port1 so when I check the static address and sticky Mac I don’t use
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
How can I check switch interface for indenpendincies or references by the way as ı remember ı use these interface just that but for your suggestion how can ı check it
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
On the FortiGate, the Network > Interfaces page, you can see the FortiGate interface connected to the FortiSwitch unit. The GUI indicates Dedicated to FortiSwitch in the IP/Netmask field. There's a column to the very far right that has clickable references.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes I checked there is no references interface that why it reason but ı recognize when I change de a vlan on wifi switch controller for that switch inteface ,switch can not apply this configuration adn when I connect to switch cli ssh and I recognized that interface which I changed the vlan on fortigate< wifi siwitc controller < fortiswitch ports ,there is no change on switch cli,I mean I use fortilink and my swtiches are managed swtich but I can not change any configuration realy my swtich ,but it is i teresting I dont see any issue for that switch and it seems autharize to fortilink,maybe that the reason for my problem how can I solve that ?
