Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
CEMS
New Contributor

Can Not Create Trunk Group Member

Hi everyone,could you help me for this issue ?

 

When I want to two interfaces on fortiswitches for trunk group.I see that warnings and it can not  allowed  for adding these interfaces.However same switch I use trunk group for different interfaces.I live that issue for 49 and 50 interfaces.Additionaly,I use managed switch with fortilink

Input value is invalid.
  • Read-only reference to trunk interface when port is a member of a trunk.
  • This port/trunk MAC value is not configurable.
  • Read-only refereUser not allowed to configure this command.
  • User not allowed to configure this command.
  • User not alnce to trunk interface when port is a member of a trunk.
  • Lowed to configure this command.
  • Error: Static/Sticky MAC entry (id=5) exists in the trunk member port port5 !!!.
  • Attribute set operator error, -651, discard the setting.
5 REPLIES 5
HarshChavda
Staff
Staff

Hello @CEMS ,

 

Can you check if the interfaces you're trying to configure might already be part of another trunk group or not.

CEMS

  • Error: Static/Sticky MAC entry (id=5) exists in the trunk member port port5 !!!. Also this warning change when I try different ports for example sometimes  port4,port1 so when I check the static address and sticky Mac I don’t use 
CEMS
New Contributor

How can I check switch interface for indenpendincies or references by the way as ı remember ı use these interface just that but for your suggestion how can ı check it

calink
Staff
Staff

On the FortiGate,  the Network > Interfaces page, you can see the FortiGate interface connected to the FortiSwitch unit. The GUI indicates Dedicated to FortiSwitch in the IP/Netmask field. There's a column to the very far right that has clickable references.

CEMS
New Contributor

Yes I checked there is no references interface that why it reason but ı recognize when I change de a vlan on wifi switch controller for that switch inteface ,switch can not apply this configuration adn when I connect to switch cli ssh and I recognized that interface which I changed the vlan on fortigate< wifi siwitc controller < fortiswitch ports ,there is no change on switch cli,I mean I use fortilink and my swtiches are managed swtich but I can not change any configuration realy my swtich ,but it is i teresting I dont see any issue for that switch and it seems autharize to fortilink,maybe that the reason for my problem how can I solve that ?

Announcements

Select Forum Responses to become Knowledge Articles!

Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.

Labels
Top Kudoed Authors