Hello,
I have created a cli template with settings. so far I have been using ADOM version 7.2 and adding FortiGate with version 7.2.6. when adding FortiGate I selected the CLI template and clicked on Edit Metadata Variable Mapping and the variable variables appeared and I set them as needed and everything worked.
I have now upgraded both the ADOM version and the FortiGate version to 7.4 and if I add a firewall, I suddenly have no variable to set in my CLI template. Version of my Fortimanager is 7.4.2
Do you know where the fault could be?
Nominating a forum post submits a request to create a new Knowledge Article based on the forum post topic. Please ensure your nomination includes a solution within the reply.
Created on 12-26-2023 06:42 AM Edited on 12-26-2023 06:42 AM
Hello @smkml
I tried again and it looks like some problem with the ADOM version, because with ADOM version 7.2 everything is fine, after upgrading to 7.4 the settings are empty. I am sending screenshots.
Hello @Kubajs ,
Can you share the steps in GUI for this too?
" when adding FortiGate I selected the CLI template and clicked on Edit Metadata Variable Mapping"
Hello @smkml
In fortigate I entered IP address of my Fortimanager. Then, in the FortiManager I clicked on Authorize and then I selected on my templates and below them is
Hello @Kubajs ,
Seems like a bug on FMG 7.4.x, you may configure the metadata variable as per below:
HI @Kubajs ,
Metadata are moved since 7.2 from Device db to To Policy & Objects: https://docs.fortinet.com/document/fortimanager/7.2.1/administration-guide/478643/adom-level-metadat...
You can configure ADOM-level metadata variables in Policy & Objects > Object Configurations > Advanced > Metadata Variables (must create per device mapping)
https://community.fortinet.com/t5/FortiManager/Technical-Tip-Per-Device-mapping-behaviour/ta-p/26486...
https://docs.fortinet.com/document/fortimanager/7.4.1/release-notes/519207/special-notices
I have no experience with the older version of FortiManager. I know that I can find the variable metadata in Policy&Objects and in the Advanced menu. That's where I have the variables created. My problem is that I am counting these variables in the CLI Template. If I am using ADOM version 7.2, when I initially authorize the device, I select CLI Template and the variables appear as they should. If I upgrade ADOM to 7.4 and do the same device authorization, the CLI variables are already blank, see screenshots above :)
Hi @Kubajs ,
I would suggest to create a ticket trough the support portal.
Please attach the screenshots and the backup of the unit.
Best,
Select Forum Responses to become Knowledge Articles!
Select the “Nominate to Knowledge Base” button to recommend a forum post to become a knowledge article.
User | Count |
---|---|
1696 | |
1091 | |
752 | |
446 | |
228 |
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2024 Fortinet, Inc. All Rights Reserved.