- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
CASI feature not visible in proxy-based inspection mode
Hi guys,
When trying to activate the CASI feature I noticed it is not visible under System > Feature Visibility. My Fortigate is working in proxy-based mode, but the NSE4 course says it is OK:
However, the Fortinet Help says the following:
Unfortunately CASI does not work when using Proxy-based profiles for AV or Web filtering for example. Make sure to only use Flow-based profiles in combination with CASI on a specific policy.
http://help.fortinet.com/fos50hlp/54/Content/FortiOS/fortigate-whats-new-54/Top_CASI.htm
But I am not sure if that means CASI doesn't work with proxy-based mode at all or if it can be used within a profile without proxy profile.
What do you think about this? By the way, I am running firmware v5.6.2.
Regards,
Julián
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
the CASI "feature" has been removed from 5.6.
You can get the same functionality using the application control profiles.
Regards
bommi
NSE 4/5/7
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
the CASI "feature" has been removed from 5.6.
You can get the same functionality using the application control profiles.
Regards
bommi
NSE 4/5/7
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Bommi,
Ok, many thanks for clarifying!
Regards,
Julián
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Bommi,
Within the Application Control profile I can see a warning which says "97 Cloud Applications require deep inspection", which matches with NSE4 when says "When applying a CASI profile to a firewall policy, enable deep inspection in the firewall policy as CASI is basically doing deep inspection of cloud applications."
How can I know what applications requiere deep inspection? Because I am not applying deep inspection and my application controls works fine.
Regards,
Julián
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi guys,
Any idea?
Regards,
Julián