- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Bridge pair/ interface requirement
Dear Team,
I have requirement like port 1 and port 2 have to be bridge interface and there is only same Vlan/subnet which is connected to different switch. Please refer the attached snapshot and provide solution, how can I achieve in fortigate.
Thank you in advanced
- Labels:
-
FortiGate
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
maybe the easiest way would be to create a switch on the FGT that has Port 1 and 2 as members.
Then only the swithch itself has to have an ip in that subnet.
Traffic between the cisco switch will then remain subnet internal and traffic that goes outside the subnet will need some policy (and maybe routing) on the FGT.
--
"It is a mistake to think you can solve any major problems just with potatoes." - Douglas Adams
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @Umesh,
I believe that software switch is a way to go. Please refer to this document for more detail https://community.fortinet.com/t5/FortiGate/Technical-Tip-Hardware-switch-Software-switch-VLAN-switc...
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In addition to the document https://docs.fortinet.com/document/fortigate/6.2.15/cookbook/277799/software-switch
