Backup Problem with Automation Stitch

[DanieleS99]

Hi,

I have a problem with a job backup by the Automation Stitch.

When i execute the backup by automation stitch i see this error:

"Connect to ftp server 192.168.50.50...

Error code 1: File not found

Send config file to tftp server via vdom root failed.

Command fail. Return code -1"

But if i copy and paste the command in the cli console, the backup work correctly.

Any idea?

Thanks

[AlexC-FTNT]

If the commands are the same, the problem is likely with routing. 

Check that you can reach the ftp server over the correct interface from root vdom, or look in the routing table of the root vdom (this is the management vdom in your case, can't run on a different one):

get router info routing-table detail 192.168.50.50 

[DanieleS99 · Accepted solution]

Thanks for the reply Alex, 

in the end I managed to understand the problem and it did not center partially with the fortigate.
In the sense that, our tftp server, for write rights, wants an empty file to be created first with the name of the file configuration.
Only, since the fortigates are clustered, when the backup is done, the fortigate job adds the serial number in the configuration file name plus the name of the file conf create.
Consequently the configuration name did not match the empty one on the tftp server.
Thanks again.