Automate - Disable FortiSwitch port when cable is disconnected

[JimmyKhern]

Hi All,

I have a FortiSwitch which managed via a Fortigate controller. Does anyone know how to create an automate task to automatically shut a switch interface when a cable is disconnected and then only can be then enable again by an administrator? Thanks

regards

Jimmy

[AEK · Accepted solution]

Hi Jimmy

The event id should be 3269.

Check the below article for a bit similar case.

https://community.fortinet.com/t5/FortiSwitch/Technical-Tip-Configure-Stitch-to-alert-when-a-port-fr...

Hope it helps.

[JimmyKhern]

Hi AEK,

Thanks for the link. I tested and confirmed is working. 

regards

Jimmy