Auto Backup using Security Fabric/Automation Problems

[nbctcp]

HW INFO: -FGT80d OS 6.2.3

GOALS: 1. email show result PROBLEMS: only half output being emailed only until === config system replacemsg mail "partial" end config system re === I think this is because timeout when show result haven't finished   CONFIGS: config system console      set output standard end config system automation-trigger     edit "FGT2.BAK"         set trigger-type scheduled         set trigger-frequency hourly         set trigger-minute 48     next end config system automation-action     edit "FGT2-BAK"         set action-type cli-script         set required enable         set script "show"     next     edit "FGT2.BAK_email"         set action-type email         set email-to "user@gmail.com"         set email-subject "FGT2.BAK"         set email-body "%%results%%"     next end    

[anteopta]

simular problem

i use automation to automate the config backup and send an email with %%results%% to myselfe.

For some reason the FortiGate does not execute the script, it only writes the comand in the comandline and nothing else.

I know it writes the comand from the email with %%results%%, and if i look in the FTP-Server, no backup can be found.

a layer 8 problem can be excluded as (meaning: no, i did not write the comand wrong as)

1. the comandline would tell me

2. i executed the comand by hand, it worked, and copied it into the script field.

it happens on 60E, 80E and 100E, but i also have 60E and 100E where it works, so i don't think it is a problem with the model.