- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Access to both firewalls in HA
I have two Fortigate 200F I am trying to set up in an active-active HA environment to replace our current 200D firewalls. When I engage HA I lose access to the slave firewall. Is this normal behavior? Our 200Ds are in an active-active environment, and I can access both firewalls together.
Thanks.
Solved! Go to Solution.
- Labels:
-
FortiGate
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Xenitel
Let us know if you are using HA mgmt interface to access the device or some other way?
If HA mgmt interface, you need reserved mgmt interface IP to access both device
https://community.fortinet.com/t5/FortiGate/Technical-Tip-HA-Reserved-Management-Interface/ta-p/1901...
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Xenitel
Let us know if you are using HA mgmt interface to access the device or some other way?
If HA mgmt interface, you need reserved mgmt interface IP to access both device
https://community.fortinet.com/t5/FortiGate/Technical-Tip-HA-Reserved-Management-Interface/ta-p/1901...
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Well, I was just using the basic mgmt ports, but will try the HA mgmt ports instead. I will let you know. Thanks.