- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
About Fortigate config firewall acl for FG-90G
Dear seniors:
Does anyone know if FG-90G has ACL policy function?
For example, the command of "config firewall acl"
Is this function only available for models above 100?
Thank you very much if anyone can give a definite answer
(It would be better to have screenshots)
Solved! Go to Solution.
- Labels:
-
FortiGate
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @M_M_SW,
I believe acl is disabled on 90G. But it is enabled on 120G build 5259 or later.
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello @M_M_SW ,
You are right. Acl feature doesnt support all Fortigate models. You can find information about supported models in this link.
https://docs.fortinet.com/document/fortigate/7.4.3/administration-guide/898126/access-control-lists
NSE 4-5-6-7 OT Sec - ENT FW
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi : ozkanaltas
I did read this description.
But it doesn’t mention the G-series.
It is also not mentioned in the 7.0 documentation.
thank you anyway
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am running a demo 91G and had some issues with it recognizing a switch (108F) over FLink until I factory reset the switch. Was super weird as the switch registered but never settled on the FG. I highly recommend testing one setup with all the components you would use on a site - see if you can get a demo unit before you buy https://1921681254.mx/ .
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi : jackiedr1
this is an embarrassing situation.
We have indeed done a PoC of FG-90G.
But for some reasons, fortilink and config firewall acl were not tested at that time.
I’m worried about finding out after purchasing that some features are missing.
So can anyone help me take a look at the G-series?
thanks!
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @M_M_SW,
I believe acl is disabled on 90G. But it is enabled on 120G build 5259 or later.
Regards,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi : hbac
Although I am sorry to hear the above information,
But still thank you for informing me
