https://textdoc.co/gRsFYtQX07oKxfSW
Hello,
OK, I am at wit’s end. I have tried, nuked, tried again, and I am still stumped.
I cannot get traffic to flow to the exit interface from any point in the network. (Excluding the MDF firewalls. ARP entries for the ports are in the FW table.) I assume this is simpler than I think, but I am missing it. Any thoughts on the matter would GREATLY be appreciated.
The switch configs are bare as I am reverting the changes from testing.
Thanks,
D,
Hi @CusterMD ,
From the provided diagram, i can generate about 3-4 scenario. Different scenario, different troubleshooting step.
The information on the diagram is not sufficient for me to comments further.
May i know, where is the Fortinet device located? Is the Switch, Fortigate in HA?
Please put IP address too so i will be helpful to assist you with the troubleshooting step.
The Fortinet Security Fabric brings together the concepts of convergence and consolidation to provide comprehensive cybersecurity protection for all users, devices, and applications and across all network edges.
Copyright 2023 Fortinet, Inc. All Rights Reserved.