ADVPN with Multi-WAN Without SDWAN

[JGaiser]

I have an ADVPN setup with 2 hubs and several spokes.

The spokes have 2 WAN connections, the Hubs each have 1.  With standard site-to-site VPN, you can have 2 tunnels active to the same location as long as 1 interface on either side is different.  IE: both WAN 1 interface and WAN 2 interface from the spoke connect to the same WAN interface on the Hub.

When I try to do this with ADVPN, it seems to integrate some of the backup tunnel settings into the existing phase 1 settings, and there is no new phase 1 entry in the IPSEC monitor.

Can ADVPN do point to multipoint without SDWAN?

[hbac]

Hi @JGaiser,

Are you checking IPSec monitor on the hub? Are those tunnels up?

Regards,