Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
mekia
New Contributor

60F w 500 Mbps connection but routing throughput only 70 Mbps

Just upgraded the fiber at the carrier ONT from 150 Mbps to 500. But the Fortinet 60F is only delivering 70 Mbps down and 50 Mbps up on the user side. Additional info: the connection from ONT to the firewall is an existing Cat5e shielded cable.

omegle xender
3 REPLIES 3
sjoshi
Staff
Staff

Hi,

 

Could you check if the FGT system performance is fine

get sys perf status

Is there any dos policy or traffic shaping configured?

Have you tested by directly connecting the PC to FGT interface?

Is there any security profile in the policy?

Verify latency towards 8.8.8.8

If you have found a solution, please like and accept it to make it easily accessible to others.
Fortinet Certified Expert (FCX) | #NSE8-003459
Salon Raj Joshi
adambomb1219
SuperUser
SuperUser

Is your port linked at only 100mbps?

hmattar
New Contributor

Hi!

 

If you run the following command:

 

get hardware nic "name of interface connected to ONT" | grep "s_"

 

Does it show speed 1000 and full duplex?

Announcements
Check out our Community Chatter Blog! Click here to get involved
Labels
Top Kudoed Authors