I have two 600Fs in active-active HA that will be connected to two Cisco Nexus 9K NX-0S in a vPC domain.
I am new to FG attempting to determine correct port settings on the 600F for a redundant inside interface with the goal being if either N9K or 600F goes down, traffic will still flow.
Currently I have port x6 on both 600Fs connected to each N9Ks port Eth 1/2
Primary 600F port x6 – switch 1 N9K port 1/2
Second 600F port x6 – switch 2 N9K port 1/2
The N9K ports are setup as vPC/port-channel
What is the correct interface settings on the 600F to support this or is this not supported?
Thanks much for any guidance.