548d reboot loop

[Bulljeff]

After a hard power outage (over 4 hours)

 My 548d will not come back up correctly.

it's stuck in a Boot loop, it starts to boot and then I get:

undefined instruction pc : [<dff832cc>] lr : [<dff53574>] sp : dfef87c0 ip : 00000033 fp : 00000002 r10: dfef88c0 r9 : 00000033 r8 : dfefaf68 r7 : dfef88b4 r6 : dfefdb30 r5 : dfef88c0 r4 : dfef8838 r3 : dffa4530 r2 : 00000010 r1 : dfef8804 r0 : dfefdb30 Flags: nzCv IRQs off FIQs off Mode SVC_32

I can upload a firmware to the running-config and it will stay up, but if it looses power or get rebooted it goes back into the same loop