Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
5.2.4 WanOpt GUI
1 Solution
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I put in a ticket about this as we use wanopt on our 60D and 111Cs. According to tac, you can no longer configure wanopt through the gui and it cannot be enabled. All config and diagnostics must be done through the CLI now. Really frustrating as there is no mention about it in the release notes for 5.2.4 and the feature matrix shows wanopt is available on those devices. This change really makes wanopt undesirable for us as it is much harder to troubleshoot wanopt issues in the cli vs gui.
- « Previous
-
- 1
- 2
- Next »
10 REPLIES 10
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
config log disk settingBTW, you're not required to guess CLI commands. It's all documented in the "CLI Reference". This is not rocket science to look it up, or the wan opt commands.
set status {enable | disable}
end
Ede Kernel panic: Aiee, killing interrupt handler!
Ede Kernel panic: Aiee, killing interrupt handler!
- « Previous
-
- 1
- 2
- Next »