Fortinet Community

Francisco_Jose_Santo · ‎07-23-2015

Hi.

Is it possible to display on GUI Wan & Opt menu?

Thanks.

snowman386 · ‎08-14-2015

I put in a ticket about this as we use wanopt on our 60D and 111Cs. According to tac, you can no longer configure wanopt through the gui and it cannot be enabled. All config and diagnostics must be done through the CLI now. Really frustrating as there is no mention about it in the release notes for 5.2.4 and the feature matrix shows wanopt is available on those devices. This change really makes wanopt undesirable for us as it is much harder to troubleshoot wanopt issues in the cli vs gui.

View solution in original post

ede_pfau · ‎11-13-2015

config log disk setting
set status {enable | disable}
end

BTW, you're not required to guess CLI commands. It's all documented in the "CLI Reference". This is not rocket science to look it up, or the wan opt commands.

Ede

"Kernel panic: Aiee, killing interrupt handler!"

Fortinet Community

5.2.4 WanOpt GUI