5.0.1 and 5.0.2 oddities

[pkley]

So I' ve got a mix of devices I' m playing with, our internal units are a 80C and new FWF60D' s that I just programmed and installed. The 80C I upgraded from 5.0.1 to 5.0.2 because I saw a huge difference in memory utilization on a FWF40C from 5.0.1 to 2 (made no difference on the 80C) and I could' ve sworn I had full WAN OPT in the GUI before but I wasn' t ready to set it up yet, so I can' t tell for certain. However, now it' s only via CLI and I can' t find all the settings that are in 5.0.1 on my FWF60D. The FWF60D does have all the settings you could want on 5.0.1 and when I went to program a FGT60D for a customer install tomorrow I was startled to find that those settings are gone! There' s just the one setting for WAN Optimization in the CLI under config system global - set gui-wanopt-cache enable and then in the policy. What I' m unsure of is why it' s on the FWF60D, but not on the FGT80C or FGT60D.

[Dave_Hall]

Don' t have a fortigate on 5.0.x in front of me to confirm, but I' d say check the System->Admin->settings.

[romanr]

Its not on the 80C, because the 80Cs still don' t support the internal storage in 5.0. Maybe this will come later in 5.0. So the explanation for the 80Cs is easy - On the 60Cs it is there - but I don' t know about the 60Ds.