30E LAN port enable

shan · ‎07-04-2017

Hi,

I'm new to forti. I got 30E box and i was configuring. Accidentally disabled LAN port. How to enable the same back??. There is a reset button on box, how to use it to revert to factory defaults?

Thnx!

Toshi_Esumi · ‎07-04-2017

Easiest way is getting in via console port and "set status up" on the interface you took down.

If you want to use the reset button the KB for the older firmware is in tanr's comment in below thread. I would expect a 30E behaves the same.

https://forum.fortinet.com/tm.aspx?m=141982

View solution in original post

Toshi_Esumi · ‎07-04-2017

Easiest way is getting in via console port and "set status up" on the interface you took down.

If you want to use the reset button the KB for the older firmware is in tanr's comment in below thread. I would expect a 30E behaves the same.

https://forum.fortinet.com/tm.aspx?m=141982

Toshi_Esumi · ‎07-05-2017

FYI: We happened to have an FG30E temporarily today and my coworker tested the reset button. Basically one of the behaviours described on the old KB was exactly how the FG30E behaved except the time window you can push the button after a power-cycle was expanded to 60sec instead of 30sec in the doc.

shan · ‎07-06-2017

toshiesumi , Thanks for reply. Managed to up through CLI. Cheers!

30E LAN port enable

Nominate a Forum Post for Knowledge Article Creation