30E LAN port enable

[shan]

Hi,

I'm new to forti. I got 30E box and i was configuring. Accidentally disabled LAN port. How to enable the same back??. There is a reset button on box, how to use it to revert to factory defaults?

Thnx!

[Toshi_Esumi · Accepted solution]

Easiest way is getting in via console port and "set status up" on the interface you took down.

If you want to use the reset button the KB for the older firmware is in tanr's comment in below thread. I would expect a 30E behaves the same.

https://forum.fortinet.com/tm.aspx?m=141982

[Toshi_Esumi]

FYI: We happened to have an FG30E temporarily today and my coworker tested the reset button. Basically one of the behaviours described on the old KB was exactly how the FG30E behaved except the time window you can push the button after a power-cycle was expanded to 60sec instead of 30sec in the doc. 

[shan]

toshiesumi , Thanks for reply. Managed to up through CLI. Cheers!