2 WAN interfaces, both active for different protocols and no load balancing

[Raudi]

Hello,

i want to replace a LANCOM 1781EF+ with a FG100D and have now a routing problem, i don't find how co configure the FG that i have the same features.

I have 2 cable business WAN lines, where i got a fixed public IPv4 via DHCP.

I want to use the WAN2 outgoing only for VPN connections and VoIP traffic. The WAN1 should be used for normal internet access. Both public IP addresses are used for publish internal services.

How can i configure 2 WAN interfaces and split the traffic?

Outgoing: Internet Access including Client IPSec VPN's -> WAN1 IPSec VPN's and VoIP -> WAN2

Published services - incoming: TCP 80,443 -> WAN1 TCP 21,25,53,443 -> WAN2

Is this possible?

I tryed already with policy routes, but every time when i try a new configuration, something else didn't work. 

At the moment all is working, but outgoing client internet access is using both WAN interfaces.

Regards

Stefan

[Toshi_Esumi]

"set defaultgw disable" in wan1 and wan2 interface config.

[Raudi]

Yes, it's working, thank you!

But i noticed that in the GUI is now a switch:

"Retrieve default gateway from server"

Is this new in 6.0? Must be, can't believe that this switch i have missed in 5.6. as i was testing all this...