Support Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
BensonLEI
Contributor

static route to differenet SD-WAN zones

Hi, guys,

I configured two SD-WAN zones as the attached, but I can not set up static routes to different SD-WAN zones individually.

( I am using Firmware 6.4.1 - the laster version for Forti400e ).

 

 I can only find the ""SD-WAN" in static route configuration

 

 

Any suggestion, many thanks

 

3 REPLIES 3
James_G
Contributor III

You route traffic to the SDWAN as a single object, then the rules control the traffic flow. So this is by design.

BensonLEI

Hi, James_G,

Thanks for your feedback.

 

How can I set up static route to different SD-WAN zones, thx a lot

 

 

This is my configuration ( SD-WAN zones, and static routes )

 ======================================

 

config system sdwan   set status enable      config zone        edit "virtual-wan-link"      next        edit "Access_to_Internet"      next        edit "LL_link-to-16HK"     next   end   config members

.....

.....

config router static     edit 1       set distance 1       set sdwan enable   next   edit 2      set dst 10.16.7.0 255.255.255.0      set gateway 10.10.32.22      set device "port7" next

===========

 

 

 

With many thanks

 

 

 

 

 

with many thanks

Dejmak
New Contributor

Hello,

this was very annoying. Anyway, in FortiOS 7 and later, it is possible to create static static routes per SD-WAN Zones

 

Dejmak

Labels
Top Kudoed Authors