Fortinet Forum
The Forums are a place to find answers on a range of Fortinet products from peers and product experts.
kevin_bieliauskas
New Contributor

Unable to reach our destination network, from an upgrade windows 7 to Windows 10

Hello,

 

I did not find any answer to my issue on this forum,

I have an issue very strange with Forticlient VPN

 

I connected to a VPN without any problem, i get an IP from VPN range

 

When i try with Windows 7 (VM)  on VMWARE it works fine to connect, i can ping an IP (192.168......)

when i try with Windows 10 (VM) on VMWARE it works fine to connect, but when i try to ping the same IP, it does not work.

When i try with windows 10, on my laptop it works fine to connect, i can ping this iP (192.168...)

 

We try with differents version 6.0 & 7.0

we compare all our configurations.

We try to add a static route.

We remove IPV6 from our network card and adapter.

 

Please could you help me :)

 

Best regards

 

 

1 REPLY 1
Aashiq_Z
Moderator
Moderator

Hello @kevin_bieliauskas ,

 

                         Could you please confirm following information

 

- Are you using split tunnel in the VPN config, if yes can you verify the routes on the host after making the VPN connection using the following command

 

route print

 

- Please make sure you see the route for the respective IP or subnet via the tunnel, if that is verified we will need to run a sniffer on the firewall to see where the packet is being dropped.

 

Regards

 

Aashiq Zainulabdeen