Hi i am new to this, i have a FortiSwitch 1024D that can only indentify the transceiver on any given port after a reboot.
Is there a command that can refresh or reset a transceiver on a port?
It's not necessary to reboot FortiSwitch for a transceiver to be recognised. Make sure you're using a compatible transceiver (https://docs.fortinet.com/document/fortiswitch/6.4.4/fortiswitch-compatible-transceivers).
Rafael Gracioli | Consulting Systems Engineer, ADC and Switching
m: +31 6 50 28 72 99 | skype: rgracioli | e: email@example.com
Hi, the transceiver is SFP1G-LX-31 1000Base SFP 1310nm 10KM, is this compatible with this unit?
Hi, the type mentioned is supported, but you may be using a transceiver model that is not MSA compliant. I suggest that you open a case with support to have it checked.
Is there a command line that can help me check that?
I have notice the following error in the events of the fortiswitch "failed BASE ID Check Sequence" in the port where the transceiver is connected.