Firewall Stuck in Boot

[#1]

Hi Everyone, I have a 60B that is stuck in a boot loop. Does anyone know how to get out of this? Thanks in advance!!! Please stand by while rebooting the system. FGT60B (11:55-06.29.2007) Ver:04000005 Serial number:FGT60B3907505167 RAM activation Total RAM: 256MB Enabling cache...Done. Scanning PCI bus...Done. Allocating PCI resources...Done. Enabling PCI resources...Done. Zeroing IRQ settings...Done. Verifying PIRQ tables...Done. Boot up, boot device capacity: 64MB. Press any key to display configuration menu... ...... Reading boot image 1810399 bytes. System is started. Abort booting! unknown operation mode(0) The system is going down NOW !!

[Carl_Wallmark]

i think you have to format the flash and then upload a new image via tftp,

[FortiRack_Eric]

The config is corrupt, the first line of the config tells the FG unit in which mode it should start vdom yes/no and nat/rout or TP mode. As the FG60B doesn' t support alternative firmware or config the only option you have is to format the flash, reload firmware and restore config. Cheers, Eric

[#4]

Thanks for the reply Selective and Eric! Would either of you know where I can find the procedure on how to perform the tasks mentioned? Best Regards.

[Carl_Wallmark]

its easy, when booting, this line comes up: Press any key to display configuration menu... Press a key and you find a menu, first format, then upload firmware via TFTP