Description
This article explains how to configure the Office Peer with inbound and outbound routes automatically.
Scope
Fortivoice.
Solution
Starting from v6.4.x and later, the inbound and outbound routes for the Office Peer will be generated automatically when configuring the patterns.
So there is no need to create a separate inbound and outbound route for the Office Peer .
Follow the steps below in the Office Peer to make the inbound and outbound generated automatically:
- Go to Trunk -> Office Peer -> Office Peer and edit or create a new one.
For Outgoing or Outbound, type the remote extension pattern in 'Outgoing digit pattern'. For example, if the remote extensions are 3 digits from 200 to 299, so it can be typed 2XX or XXX
- For incoming or inbound, extend the 'Advanced' menu, then type the local extension pattern in 'Local/incoming digit pattern'. For example, if the local extension with 4 digits, it can be typed XXXX:
- Enable the below options to allow dialing the local numbers, route the calls, and share the directory between the two Fortivoice:
- To make sure that the inbound route has been generated and configured, go to Call Routing -> Inbound -> Office Peers. The configured patterns and options will be displayed in the Office Peers.
- To make sure that the outbound route has been generated, go to Call Routing -> Outbound -> Office Peers. The configured patterns and options will be displayed in the remote Peer.
