How to see FortiSOAR VM configuration wizard UI after quitting CLI

[pomp]

Hello Community,

I am trying to deploy FortiSOAR in my Linux VM using the .bin file using an SSH session.

After deployment, all service was running except elasticsearch service, so I decided to run the configuration wizard again to see if it may help fix the elasticsearch service issue.

However, my client (host) lost connection with the FortiSOAR (Linux VM) and I got disconnected.

I logged back into my FortiSOAR VM and I'm told this:

"FortiSOAR VM configuration is in progress.

Please allow the VM configuration process to complete before running any operation."

My question is how can I switch back to the wizard to see the progress of the configuration wizard.

Best Regards.

[TejaMula]

Hi pomp,

Since the connection was lost, cannot get back to the wizard.

Can see the status of the wizard by tailing the log file though.

Location -> /var/log/cyops/install/config-vm-<timestamp>.log

And,

/home/csadmin/.vm_configured file gets created by the config wizard upon successful completion

/home/csadmin/.vm_configuration_fail file gets created by the config wizard upon failure. In case of failure, check the log file, address the issues and re-run the config wizard.

Regards,

Tejas.