Technical Tip: How to re-deploy Security PoP

[shafiq23]

Description	This article describes how to re-deploy the Security PoP if there are changes in the network setup related to FortiGate’s network interface and routing.
Scope	FortiSASE-Sovereign, FortiGate.
Solution	Requirement: Changes in FortiGate network interfaces, such as dual-ISP deployment or default static route priority change. Delete Security PoP in FortiSASE-Sovereign portal: Device -> Security PoPs > select Security PoP > select ‘Remove Selected’. Wait until deletion completes: Disable FortiSASE-Sovereign setting in FortiGate CLI console: config system sov-sase     set status disable end FortiGate will reset to factory default. Re-configure FortiGate appliance according to guidelines in FortiSASE-Sovereign deployment guide and apply necessary changes required in the deployment: Set Up FortiGate Appliance Re-deploy Security PoP. Related document: Best Practices and Recommendation